Stetsom BRAVO FULL 2K Digital Full-Range Amplifier Mono 1 Channel Class D 2000 Watts RMS

The Stetsom BRAVO FULL 2K is a digital, full-range mono amplifier (1 channel, Class D) built for power-hungry car-audio enthusiasts who demand serious single-channel output. It provides extreme impedance and voltage flexibility, including up to 3,500W RMS at 1 Ohm with 14.4V and 3,100W at 1 Ohm with 12.6V, plus substantial authority at 2 Ohms across both voltages.

• Number of Channels: 1 — Mono, dedicated one-channel amplification ideal for a subwoofer or single high-performance driver in a premium install.
• RMS Power at 1 Ohm @ 14.4V: 3500W — Very high power capability for demanding low-impedance loads, providing substantial headroom for dynamic bass.
• RMS Power at 2 Ohms @ 14.4V: 2100W — Still strong at a higher impedance, suitable for efficient loads or multi-coil subs.
• RMS Power at 1 Ohm @ 12.6V: 3100W — Maintains substantial output when vehicle voltage is around battery level, common during engine idle.
• RMS Power at 2 Ohms @ 12.6V: 2000W — Strong performance at 2 Ohms across typical vehicle voltages.
• Minimum input sensitivity: 200mV — Enables full output from lower-level head-unit signals, reducing the need for high-gain inputs.
• Signal to noise ratio: >90dB — Low noise floor to preserve music detail even at higher output levels.
• Frequency response (-3dB): 10Hz ~ 22KHz — Wide bandwidth for accurate bass through treble, suitable for full-range signals when desired.
• Crossover low pass: 90Hz ~ 22KHz — Lets you tailor bass roll-off to match subwoofers or full-range setups for clean separation.
• Crossover high pass: 10Hz ~ 90Hz — High-pass filtering to block subsonics or to aid integration with other speakers in a multi-amp system.
• Bass boost: Freq: 30Hz ~ 70Hz / Boost: 0dB ~ +10dB — Adjustable bass emphasis to fine-tune impact without altering the overall tonal balance.
• Input impedance: 18K Ohms — Light load on the head unit, helping preserve signal integrity across typical RCA runs.
• Supply voltage: 9V ~ 16V DC — Designed for the typical automotive electrical range, including battery and alternator variations.
• Musical/Bass consumption: 160A/320A — Indicates the current demand behind dynamic musical peaks and bass-heavy content, guiding power and wiring requirements.
• Dimensions (1 Ohm): 3.14" x 9.11" x 9.29" / Weight: 6.39 lb — Physical footprint suitable for under-seat or trunk installations with substantial cooling and clearance.
• Dimensions (2 Ohms): 3.14" x 9.11" x 7.75" / Weight: 4.96 lb — Slightly shallower profile at 2 Ohms, offering installation flexibility while maintaining performance.

This mono amplifier excels in premium builds that require a single, high-current channel with broad frequency capability and flexible crossover control. Its wide voltage compatibility and multiple impedance/power configurations make it a versatile choice for dedicated subwoofer deployments or standalone mono-channel racks in advanced car audio systems.